Cisco Headend System Release 2.7 Installation Guide
Appendix B
Restarting System Components
208
740020 Rev H
Restart System Components
Introduction
Follow these procedures to restart Spectrum, the DNCS, and the Application Server.
Restarting Spectrum
Follow these instructions to restart Spectrum.
Note: Skip this procedure if you are using Alarm Manager, instead of Spectrum.
1 From the DNCS Administrative Console Status window, click Control in the
1 From the DNCS Administrative Console Status window, click Control in the
NMS section of the window. The Select Host to run on window opens.
2 Select the Host Machine (usually DEFAULT), and then click OK. The Spectrum
Control Panel window opens.
3 On the Spectrum Control Panel window, click Start SpectroSERVER. The
Spectrum Network Management System starts.
4 On the Spectrum Control Panel window, click Exit. A confirmation message
appears.
5 Click OK on the confirmation message. The Spectrum Control Panel window
closes.