Cisco Headend System Release 2.5 Installation Guide
740020 Rev H
165
Introduction
The check_metadevices utility constantly monitors the state of the
metadevices on an Enterprise 450 or Sun Fire 880 DNCS and then
reports any errors it finds. The utility runs automatically after you
install the DBDS Utilities; system operators or engineers do not have
to invoke any specific commands to run the check_metadevices utility.
metadevices on an Enterprise 450 or Sun Fire 880 DNCS and then
reports any errors it finds. The utility runs automatically after you
install the DBDS Utilities; system operators or engineers do not have
to invoke any specific commands to run the check_metadevices utility.
Notes:
A metadevice is a group of physical devices accessed through a
virtual or logical device.
virtual or logical device.
The check_metadevices utility replaces the sdsCheck utility, which
was part of the CoolTools suite of utilities in DBDS Utilities
version 2.2.
was part of the CoolTools suite of utilities in DBDS Utilities
version 2.2.
14
Chapter
14
Monitor the Status of System
Metadevices with the
Metadevices with the
check_metadevices Utility
In This Chapter