Cisco Headend System Release 2.7 Installation Guide
Chapter 2 SR 5.0 Pre-Upgrade Procedures
28
4035749 Rev B
Mount the DVD
Depending upon your current Solaris patch set, the DVD may not mount
automatically. Use the following chart to determine what method to use to mount
the DVD.
automatically. Use the following chart to determine what method to use to mount
the DVD.
DNCS Release SAIpatch Set
DVD Mount Method
SR 4.2
4.2.1.6 and older Manually mount
SR 4.2
4.2.1.10
Automount
SR 4.3
4.3.0.1
Manually mount
SR 5.0
10.20100322.2
Automount
Use the appropriate DVD mounting method for your current installation.
Important:
Important:
If you only have one DVD, you will need to complete this procedure each time
you move the DVD from one system to another.
you move the DVD from one system to another.
To unmount a DVD, type cd / and then type
umount /cdrom/cdrom
.
Note: You should have an SR 5.0 DVD for each server that you are upgrading.
Repeat this procedure for each DNCS and RNCS server that you are upgrading.
Repeat this procedure for each DNCS and RNCS server that you are upgrading.
Automount the DVD
Follow these steps to automount the DVD.
1 Inspect the DVD to ensure that it is clean. There should be no smudges on the
1 Inspect the DVD to ensure that it is clean. There should be no smudges on the
DVD. Some small, light scratches may be present; this is fine.
2 Insert the system release installation DVD into the CD-ROM drive of the server.
3
3
Did the DVD automount?
If yes, continue with the next procedure in this chapter.
If no, as root user, type the following command and press Enter to restart the
volfs process.
volfs process.
svcadm restart volfs
Note: If the DVD still does not automount, contact Cisco Support for
assistance.
assistance.