Cisco Headend Digital Broadband Delivery System Installation Guide
Chapter 4 Install the ASI Server Software
90
78-4004034-01 Rev C
Install the ASI Server Software
Introduction
After you install Solaris onto the ASI server, you can complete the procedure in this
section to install the ASI Server software.
CAUTION:
The procedures in this chapter are used to install xOD on a new
system. If you are upgrading an existing xOD system, use the
procedures listed in Appendix A and Appendix B. Failure to do so may
erase your xOD configuration.
Before You Begin
Before you perform the server software installation, you must complete the
following tasks.
1 Have the ASI Server 1.6.0 CD.
2 Make sure the following file systems were created when you installed Solaris:
1 Have the ASI Server 1.6.0 CD.
2 Make sure the following file systems were created when you installed Solaris:
/export/home
/u00
/u01
/u02
/u03
/u04
/u05
/u06
/backups
Important: You must create the /u00, /u01, /u02, /u03, and /u04 file systems
before you begin the server installation procedure. Otherwise, the installation
process creates these as directories under the root file system and you may run
out of disk space.
3 If you have an ISA environment, make sure that the ASI server host name (asi)
and IP address are listed in the /etc/hosts file on the name server. You will
configure the hosts file on the ASI server later in this chapter.
Time to Complete
Installing the ASI Server software takes approximately 2 hours to complete.