Cisco Headend System Release 2.7 Installation Guide
Examine and Re-Order the pddataqampat Table
4036631 Rev B
79
Tear Down Session ID 199
Begin the process of re-ordering the pddataqampat table by tearing down session ID
199. Follow these instructions to tear down session ID 199.
Note: From an xterm window on the DNCS where you are logged on as dncs user,
you can run the clearDbSessions, clearDbSessions -c, and clearDbSessions -o commands
to remove expired sessions from the BFS. This will clean up the Session List UI and
allow you to see only those sessions that have been rebuilt.
1 From the DNCS tab on the DNCS Administrative Console, select Utilities and
199. Follow these instructions to tear down session ID 199.
Note: From an xterm window on the DNCS where you are logged on as dncs user,
you can run the clearDbSessions, clearDbSessions -c, and clearDbSessions -o commands
to remove expired sessions from the BFS. This will clean up the Session List UI and
allow you to see only those sessions that have been rebuilt.
1 From the DNCS tab on the DNCS Administrative Console, select Utilities and
then click Session List. The Sessions Filters window appears.
2 Highlight BFSqam and then click Display at the bottom of the window. The
window updates to display session data for the BFS QAM.
3 Does the data show that session ID 199 directly follows session ID 22, and that
session ID 199 has a session MAC address of 00:00:00:00:00:00?
If yes (to both conditions), close all session-related windows and skip this
entire section; go to the next procedure in this chapter.
entire section; go to the next procedure in this chapter.
If no (to at least one condition), continue with step 4.
4 Click the checkbox associated with session ID 199.
Note: Session ID 199 is likely to be at the bottom of the window.
5 Click Teardown. The system tears down the selected session.
6 Wait a few minutes for the BFS sessions to rebuild.
7 Confirm that the rebuilt BFS session ID 199 now has a session MAC address of
6 Wait a few minutes for the BFS sessions to rebuild.
7 Confirm that the rebuilt BFS session ID 199 now has a session MAC address of
00:00:00:00:00:00 and that it follows session ID 22.
Checking the pddataqampat Table-ASI
After upgrading to SR i4.2.2, follow these instructions to inspect the contents of the
pddataqampat table and then to re-order the table, if necessary.
1 From the DNCS Administrative Console, select the Application Interface
pddataqampat table and then to re-order the table, if necessary.
1 From the DNCS Administrative Console, select the Application Interface
Modules tab and then click BFS Admin. The BFS Admin Sites window opens.
Note: If the RCS feature is not enabled on the system, the Site DNCS BFS
Administration window appears instead.
Note: If the RCS feature is not enabled on the system, the Site DNCS BFS
Administration window appears instead.
2 Double-click the appropriate Site Name. The Site [site name] BFS Administration
window opens.
Note: You will probably want to examine the pddataqampat table on the DNCS
first, before you examine any remote sites.
Note: You will probably want to examine the pddataqampat table on the DNCS
first, before you examine any remote sites.