Cisco Model D-PCG1000 PowerKEY CAS Gateway Installation Guide
Chapter 2 Getting Started
10
736138 Rev F
Unpack the TED FX Server
Introduction
To successfully install the TED FX server in your headend, you must unpack the
TED FX server from the carton and verify all parts and quantities. This section
provides instructions for unpacking the TED FX server from the carton.
Unpacking the TED FX Server
Complete these steps to unpack the TED FX server from the carton.
1 Open and remove all packing material from the carton.
2 Initial next to the following items to verify that your shipment includes the parts
1 Open and remove all packing material from the carton.
2 Initial next to the following items to verify that your shipment includes the parts
and quantities listed:
TED FX server (1) _____
Power Cord (1) _____
RJ-45 cross-over cable, 10 inches (1) _____
Adjustable rack brackets, for rack-mounted version (2) _____
Universal chassis fastener (1) _____
Chassis Padlock Key for securing the chassis (1) _____
Note: After installation, store the Chassis Padlock Key in the same secure
location as your portion of the CAA Pass Phrase.
3 Are any parts missing?
If yes, see Customer Support (on page 36) of this guide for contact
information.
If no, go to step 4.
4 Inspect all of the parts, including the TED FX server, for visible damages.
5 Are there any visible damages on any of the parts?
5 Are there any visible damages on any of the parts?
If yes, see Return Products for Repair (on page Error! Bookmark not
defined.).
If no, go to step 6.
6 Read all the safety and operating instructions accompanied with this product.
7 Go to
7 Go to
Installing the TED FX Server (on page 11).