Cisco Model D-PCG1000 PowerKEY CAS Gateway Installation Guide
6-Disk Configuration
4005697 Rev C
15
Replace a Hard Disk Drive (6-Disk Setup)
Installing a New Hard Disk
If you have any questions about the equipment, refer to your copy of the Owner's
Guide before proceeding with these instructions.
If you have any questions about the equipment, refer to your copy of the Owner's
Guide before proceeding with these instructions.
CAUTION:
Static sensitive device. Always wear a properly grounded wrist strap when
working on this equipment. Failure to observe this caution may result in
equipment damage or premature equipment failure.
Static sensitive device. Always wear a properly grounded wrist strap when
working on this equipment. Failure to observe this caution may result in
equipment damage or premature equipment failure.
Use the instructions in this section to install a new hard disk into your V880 or V890.
Refer to the following illustration for guidance as you complete this procedure.
Refer to the following illustration for guidance as you complete this procedure.
Note: Use only Sun Microsystems Inc. (Sun) internal 72 GB, 10000 RPM, 1-in. high,
UltraSCSI disk drives (Sun part number 5234A).
1 Swing open the disk drive bay door on the front of the V880/V890. Three
UltraSCSI disk drives (Sun part number 5234A).
1 Swing open the disk drive bay door on the front of the V880/V890. Three
columns of internal drive bays are exposed.
2 Remove the new hard disk from its protective packaging.
3 Slide the thumb latch UP on the old hard disk. The silver drive handle on the
3 Slide the thumb latch UP on the old hard disk. The silver drive handle on the
hard disk swings down.