Cisco Model D-PCG1000 PowerKEY CAS Gateway Installation Guide
Chapter 1 Replace a Disk Drive on a Sun Fire V880 and V890 Server
16
4005697 Rev C
CAUTION:
Allow approximately 30 seconds for the hard disk drive to spin down
completely before removing the drive from the drive bay. Failure to
observe this caution may result in equipment damage.
Allow approximately 30 seconds for the hard disk drive to spin down
completely before removing the drive from the drive bay. Failure to
observe this caution may result in equipment damage.
4 Holding the silver drive handle, remove the old hard disk from the drive bay.
5 Complete the following steps to install the new hard disk.
5 Complete the following steps to install the new hard disk.
a Orient the new hard disk so that the silver drive handle is on the bottom.
b Using the drive bay guide rails, slide the new disk drive halfway into the
b Using the drive bay guide rails, slide the new disk drive halfway into the
drive bay.
Important: Do not slide the new disk drive completely into the drive bay at
this time. You must put the new drive in the online state first before you can
complete the disk installation.
this time. You must put the new drive in the online state first before you can
complete the disk installation.
Note: In the event that the new disk drive arrives without guide rails, attach the
guide rails from the old disk drive to the new disk drive.
guide rails from the old disk drive to the new disk drive.
6 Go to
Putting the New Disk Drive Into an Online State (on page 16).
Putting the New Disk Drive Into an Online State
Before you can complete the new disk drive installation, you have to put the new
disk drive into an online state.
Before you can complete the new disk drive installation, you have to put the new
disk drive into an online state.
CAUTION:
Static sensitive device. Always wear a properly grounded wrist strap when
working on this equipment. Failure to observe this caution may result in
equipment damage or premature equipment failure.
Static sensitive device. Always wear a properly grounded wrist strap when
working on this equipment. Failure to observe this caution may result in
equipment damage or premature equipment failure.
Complete these steps to put the new disk drive in the online state.
Note: If you have been following the procedures in this chapter in order, you should
still be logged in to an xterm window as root user.
1 Type the following command and press Enter:
Note: If you have been following the procedures in this chapter in order, you should
still be logged in to an xterm window as root user.
1 Type the following command and press Enter:
luxadm insert_device
2 Press Enter again.
3 Complete the following steps to install the new hard disk.
3 Complete the following steps to install the new hard disk.
a Slide the hard disk completely into the drive bay and seat it securely against
the back plane of the server.
b Swing the silver drive handle closed until it latches.
Note: When you latch the silver drive handle, it engages the hard disk with its
back plane connector.
Note: When you latch the silver drive handle, it engages the hard disk with its
back plane connector.
4 Is the green LED for the newly installed hard disk illuminated?