Cisco Headend System Release 2.7 Installation Guide
Installation Overview
4022447 Rev B
3
Installation Overview
The following table lists the steps required for the RNCS software initial installation,
where the section for each step begins in this document, and the information
required for each procedure.
where the section for each step begins in this document, and the information
required for each procedure.
Step Procedure
Reference
Parameters Required
1
Record all the information
required for non-default BFS
sources (such as multiple
bootloader or VCS sources)
required for non-default BFS
sources (such as multiple
bootloader or VCS sources)
You will re-create these
sources on the RNCS later
sources on the RNCS later
Before You Begin (on
page 2)
page 2)
Source Name
Source ID
Source Type
Transport Type
Data Rate
Block Size
Indication Interval
Data Pump
Available Hosts
2
Log onto the RNCS servers
N/A
3
Configure the ALOM port
Configure the ALOM
Port (on page 13)
Port (on page 13)
Password for admin
Unique IP address for network management
port
port
Netmask of the network management port
IP address for gateway or router of the
network management port
network management port
4
Connect to the Console of the
RNCS server
RNCS server
IP address of the ALOM port
Admin user ID
Admin user password
5
Install the RNCS software
Install the RNCS
Software (on page 17)
Software (on page 17)
Host name of the new RNCS
IP address of the new RNCS
Netmask of the new RNCS
Router IP address for bge0 interface
Your current time zone and region
Root password for the new RNCS
Run the create_sysidcfg
Script
Script
IP address of the dncsatm