Cisco Headend System Release 2.7 Installation Guide
Install the RNCS Software
4012763 Rev B
21
27 Type /cdrom/cdrom0/sai/scripts/create_sysidcfg and then press Enter in order to
write system ID information into memory (nvramrc).
Running the create_sysidcfg Script
The create_sysidcfg script creates a sysidcfg file in a specified directory and writes
system identification configuration information to the nvramrc file. Complete the
following steps to run the create_sysidcfg script.
1 Type /cdrom/cdrom0/s0/sai/scripts/create_sysidcfg /var/tmp and then press
1 Type /cdrom/cdrom0/s0/sai/scripts/create_sysidcfg /var/tmp and then press
Enter. The system displays the Enter IP Address of dncsatm [default: 10.253.0.1]
message.
2 Is the default IP address correct?
If yes, press Enter.
If no, type the correct IP address for dncsatm and then press Enter.
Result: The following message appears:
Restarting ntp
Restarting ntp
Sysidcfg information written successfully to nvramrc
Note: Disregard any not found message.
Note: Disregard any not found message.