Cisco Headend System Release 2.7 User Guide
749640 Rev D
Track Progress of the emmDistributor With the emmlst Utility
6-3
Run the emmlst Utility,
Continued
3.
Choose one of the following options:
•
•
If it has been a very short time (within the hour) since you last ran the
emmlst utility, type y and then press Enter.
Note: If it has been a very short time since you last ran the emmlst utility,
Note: If it has been a very short time since you last ran the emmlst utility,
the number of DHCTs in the database probably has not changed. You can
safely use the existing distribution list.
•
If it has been several hours (or longer) since you last ran the emmlst utility,
type n and then press Enter.
Note: If it has been several hours or if a lot of staging activity has taken
Note: If it has been several hours or if a lot of staging activity has taken
place since you last ran the emmlst utility, the number of DHCTs in the
database may have changed. You should probably request that the emmlst
utility generate a fresh list.
Result: The emmlst utility runs and displays information pertaining to the
progress of the emmDistributor process as it cycles through the database, as
well as how long it takes the emmDistributor process to distribute EMMs to
the entire DHCT population.
Example: Sample output from the emmlst utility follows:
Example: Sample output from the emmlst utility follows:
The last MAC sent EMMs was: 00:01:A6:55:BC:3C
This is MAC 82007 of 101012
This is 81% of the way through the list of MACS
EMMS are being sent to DHCTs
at 5.0 second intervals on this system
To change this value, update/add the variable
EMM_DIST_THROTTLE in the dncs .profile, and
bounce the emmDistributor process.
It would take 1 days, 3 hours, and 0 minutes
to complete the distribution list from this point.
Total cycle time is: 5 days, 22 hours, and 5 minutes.