Cisco Headend System Release 2.7 User Guide
8-12
Transmit DHCT Billing Transactions With the IIH Utility
749640 Rev D
Reset DHCT NVM With the resetClientNvm Transaction
Introduction
The resetClientNvm transaction resets the non-volatile memory (NVM) of a DHCT
to default settings established at the factory. The procedures in this section provide
detailed instructions on resetting the NVM of an individual DHCT, a list of DHCTs,
or DHCTs of a specific model number.
Note: The –r option, which is used to reset the NVM, is not a valid option at sites
Note: The –r option, which is used to reset the NVM, is not a valid option at sites
that use the Pioneer application server. The –r option is valid only at sites that use
the Cisco Application Server. When the –r option is used at a site that uses the
Pioneer application server, the system displays the following message:
’r’ function is not supported by Pioneer AppServer
(assumed since saManager is not running)
Resetting the NVM of an Individual DHCT
Follow these instructions to reset the NVM of an individual DHCT.
1.
If necessary, open an xterm window on the DNCS.
2.
Type IIH -r [DHCT MAC address] and then press Enter.
Notes:
•
Notes:
•
Substitute the MAC address of the DHCT for [DHCT MAC address].
•
The MAC address can be formatted with or without colons ( : ).
Examples:
•
•
IIH -r 00:02:DE:A6:45:92
•
IIH -r 0002DEA64592
Result: The system resets the NVM of the specified DHCT.
Resetting the NVM of a List of DHCTs
Follow these instructions to reset the NVM of a list of DHCTs. You should already
have prepared the list of DHCTs, identified by MAC address, according to the
guidelines and instructions in the Prepare a Text File section, earlier in this chapter.
Note: When the IIH utility processes a list of DHCTs, the transaction processes ten
Note: When the IIH utility processes a list of DHCTs, the transaction processes ten
DHCTs at a time, by default. The reason ten DHCTs are processed at a time is to
avoid monopolizing the bossServer process of the DNCS. If you have an urgent need
to process more DHCTs than ten at a time, you can override the default value
through use of the –C parameter.
1.
If necessary, open an xterm window on the DNCS.
Continued on next page