Cisco Headend System Release 2.5 User Guide
5-8
Examine the Database for Expiring EMMs With the emm_check Utility
749640 Rev C
Bounce the camAuditor Process
Introduction
When the emm_check utility runs the third database check, Cisco Services engineers
may request that you bounce the camAuditor process. Follow these procedures to
bounce the camAuditor process.
Note: When you bounce a process, you stop the process and then restart it.
Note: When you bounce a process, you stop the process and then restart it.
Stopping the camAuditor Process
Follow these instructions to stop the camAuditor process.
1.
On the DNCS Control window, highlight the camAuditor process.
2.
Click Process and then select Stop Process.
Result: A confirmation message appears.
Result: A confirmation message appears.
3.
Click OK.
Result: In a few minutes, the indicator for the camAuditor process changes
Result: In a few minutes, the indicator for the camAuditor process changes
from green to red.
4.
Wait a few minutes and then highlight again, if necessary, the camAuditor
process
5.
Click Process and then select Start Process.
Result: A confirmation message appears.
Result: A confirmation message appears.
6.
Click OK.
Result: In a few minutes, the indicator for the camAuditor process changes
Result: In a few minutes, the indicator for the camAuditor process changes
from red to green.