Cisco Headend System Release 2.7 User Guide
Appendix C
Provisioning Services for SDV in an RNCS Environment
90
4024447 Rev C
7 Select or enter the following values for the stream delivery type you selected in
step 6:
INPUT
INPUT
Stream Delivery Type: Select Multicast.
Source IP Address 1: (optional): The IP address of the staging processor (for
example, DCM, Mentor, BMR, or Terayon device) interface that is sourcing
the video at the remote site.
example, DCM, Mentor, BMR, or Terayon device) interface that is sourcing
the video at the remote site.
Source IP Address 2 (optional): The IP address of an additional staging
processor interface that is sourcing the video at the remote site. An additional
staging processor provides redundancy, if needed.
processor interface that is sourcing the video at the remote site. An additional
staging processor provides redundancy, if needed.
Source IP Address 3 (optional): The IP address of an additional staging
processor interface that is sourcing the video at the remote site. An additional
staging processor provides redundancy, if needed.
processor interface that is sourcing the video at the remote site. An additional
staging processor provides redundancy, if needed.
Destination IP Address: The destination IP address of the multicast stream
incoming to the Netcrypt device.
incoming to the Netcrypt device.
UDP Port: The destination UDP port number for the incoming content.
OUTPUT
Stream Delivery Type: Select Multicast.
Destination IP Address: The multicast IP address for the destination output
source that the Netcrypt device is sending video to.
source that the Netcrypt device is sending video to.
Output (optional): The destination UDP port that the Netcrypt device will
use when sending the content to the network.
use when sending the content to the network.
8 Click Save.
9 Do you need to create an additional source definition for this service ID?
9 Do you need to create an additional source definition for this service ID?
If yes, repeat steps 1–8.
If no, you have completed this procedure and should refer to the flow chart
in Adding a New Source ID (on page 85) to complete the remaining
provisioning procedures.
in Adding a New Source ID (on page 85) to complete the remaining
provisioning procedures.