Cisco Headend System Release 2.7 User Guide
Add Source IDs for SDV Services in an RNCS Environment
4024447 Rev C
89
5 Click Multicast through a netcrypt and then click Next. The Multicast Digital
Session Definition window opens.
6 Enter the appropriate values in the following fields:
Bandwidth (Mbps): Enter the bandwidth rate for the SDV service.
Netcrypt: Select the Netcrypt device at the remote location that will be
multicasting the content for this service group.
multicasting the content for this service group.
Netcrypt Port: Select the Netcrypt GbE port that will be multicasting the
content (the same port that is receiving the content from the staging
processor or other source).
content (the same port that is receiving the content from the staging
processor or other source).
MPTS: Leave this option disabled. Enabling MPTS indicates that the
incoming stream to the Netcrypt is a Multiprogram Transport Stream
(MPTS).
Important: In an SDV environment, SPTS (Single Program Transport Stream)
should be the standard; therefore, MPTS should never be enabled.
incoming stream to the Netcrypt is a Multiprogram Transport Stream
(MPTS).
Important: In an SDV environment, SPTS (Single Program Transport Stream)
should be the standard; therefore, MPTS should never be enabled.
SDV Session: Check the SDV Session check box to enable the SDV session.
Program Number (is active only when MPTS is selected): You do not need to
enter a program number in an SDV environment. Go to step 7.
enter a program number in an SDV environment. Go to step 7.