Cisco Headend System Release 2.7 User Guide
Chapter 2 Provisioning SDV Services on the DNCS
22
4024447 Rev C
Set Up a Netcrypt Bulk Encryptor
Overview
This section provides instructions for completing each of the following tasks that are
required to provision a Netcrypt Bulk Encryptor on the DNCS.
1 Add a Netcrypt element to the DNCS, but do not place the element online.
2 Provision the Ethernet ports on the Netcrypt element.
required to provision a Netcrypt Bulk Encryptor on the DNCS.
1 Add a Netcrypt element to the DNCS, but do not place the element online.
2 Provision the Ethernet ports on the Netcrypt element.
Content is encrypted based on the DNCS control. Provisioning a Netcrypt Bulk
Encryptor establishes communication between the DNCS and the Netcrypt Bulk
Encryptor. Without DNCS control, the Netcrypt Bulk Encryptor is inoperable.
Encryptor establishes communication between the DNCS and the Netcrypt Bulk
Encryptor. Without DNCS control, the Netcrypt Bulk Encryptor is inoperable.
Note: For detailed information about the Netcrypt device, refer to the Netcrypt Bulk
Encryptor Hardware Installation and Operation Guide (part number 4001444).
Encryptor Hardware Installation and Operation Guide (part number 4001444).
Adding a Netcrypt Bulk Encryptor
1 From the Network Element Provisioning tab on the SDV Administrative
Console, click Netcrypt. The Netcrypt List window opens and shows any
Netcrypt elements that have been provisioned on the DNCS.
Netcrypt elements that have been provisioned on the DNCS.
2 Click Add. The New Netcrypt window opens.