Cisco Model D-PCG1000 PowerKEY CAS Gateway Release Notes
Chapter 2 Upgrading the Software
22
4011046 Rev B
5 Type prompt and press Enter. The system indicates that interactive mode is off.
6 Type mget * and press Enter. The system begins copying the file (or files) from
6 Type mget * and press Enter. The system begins copying the file (or files) from
the FTP site to the current directory on your DNCS.
7 Type bye and press Enter to log out of the Cisco FTP server.
8 Go to Decompressing and Extracting the File (on page 22).
8 Go to Decompressing and Extracting the File (on page 22).
Decompressing and Extracting the File
1 From the xterm window, type gzip -d GQAM40.tar.gz and press Enter. The
1 From the xterm window, type gzip -d GQAM40.tar.gz and press Enter. The
system decompresses the GQAM software file.
2 Type tar xvf GQAM40.tar and press Enter. The system extracts the individual
files.
3 Go to Installing GQAM Software (on page 22).
Installing GQAM Software
1 From the xterm window where you are logged in as root, type
1 From the xterm window where you are logged in as root, type
/usr/sbin/install_pkg and press Enter.
Results:
Results:
The system lists the packages that will be installed.
A confirmation message appears asking you to confirm that you want to
proceed with the installation.
proceed with the installation.
2 Type y and press Enter to start the installation.
Note: The installation should take less than 30 seconds.
3 Did a message appear indicating that the installation was successful?
If yes, go to step 4.
If no, contact Cisco Services.
4 Use the UNIX rm -rfi command to remove the following file and directory:
GQAM40.tar (file)
SAIGQAM (directory)
Example: Type rm –rf SAIgqam GQAM40.tar and press Enter.
Result: A confirmation question message appears asking you to confirm the
removal.
Result: A confirmation question message appears asking you to confirm the
removal.
5 Type exit and press Enter to log out as root user.
6 Type exit and press Enter to close the xterm window.
7 Go to Establish a Download Sequence (on page 23).
6 Type exit and press Enter to close the xterm window.
7 Go to Establish a Download Sequence (on page 23).