Cisco Headend System Release 2.5 Installation Guide
Chapter 2 DNCS Pre-Upgrade Procedures
38
4042389 Rev A
Terminating the cmd2000 Utility
Complete the following steps to determine if any cmd2000 processes are running
and then to terminate them, if necessary.
1 If necessary, open an xterm window on the DNCS.
2 Type ps -ef | grep cmd2000 and press Enter. The system displays a list of
and then to terminate them, if necessary.
1 If necessary, open an xterm window on the DNCS.
2 Type ps -ef | grep cmd2000 and press Enter. The system displays a list of
cmd2000 processes.
3 Do the results from step 2 show any active cmd2000 processes?
If yes, choose one of the following options:
–
–
If you have a SA Application Server, type kill -9 <processID> and then
press Enter for any cmd2000 processes that may be running.
press Enter for any cmd2000 processes that may be running.
–
If you have an Aptiv Application Server, type
/pdt/bin/StopCmd2000Logging and then press Enter.
/pdt/bin/StopCmd2000Logging and then press Enter.
–
If you have a MAS server, refer to the documents supplied by Mystro to
stop the active cmd2000 processes on the MAS server.
stop the active cmd2000 processes on the MAS server.
If no, go to Back Up and Delete the copyControlParams File (on page 39).
4 Type ps -ef | grep cmd2000 again and then press Enter to confirm that all
cmd2000 processes are stopped.
5 Do the results from step 4 show that there are cmd2000 processes that are still
running?
If yes, type kill -9 <processID> and then press Enter for any cmd2000
processes that may be running; then, repeat steps 4 and 5.
processes that may be running; then, repeat steps 4 and 5.
If no, go to Back Up and Delete the copyControlParams File (on page 39).