Cisco Headend System Release 2.5 Installation Guide
Verify the .profile Entries
4038415 Rev A
23
Verify the PSIP and SI_REGENERATION_TIME Variables
The following procedure checks the PSIP_INSERT_RATE and
SI_REGENERATION_TIME variables for their recommended values. A brief
explanation of why you are checking these variables follows.
SI_REGENERATION_TIME variables for their recommended values. A brief
explanation of why you are checking these variables follows.
PSIP_INSERT_RATE
If the site you are upgrading does not use the DNCS for PSIP and inband EAS
messages that are targeted to hosts, such as QAM tuner TVs, you can disable
delivery of these messages from the DNCS by setting the PSIP_INSERT_RATE
variable to 0 in the .profile file. If you are not using the DNCS to provide these
messages, you should make provisions to provide these signals by other PSIP
aggregation/EAS equipment in your system.
messages that are targeted to hosts, such as QAM tuner TVs, you can disable
delivery of these messages from the DNCS by setting the PSIP_INSERT_RATE
variable to 0 in the .profile file. If you are not using the DNCS to provide these
messages, you should make provisions to provide these signals by other PSIP
aggregation/EAS equipment in your system.
Important:
Be aware that there are FCC regulatory requirements to provide PSIP and EAS to
these devices.
these devices.
If the DNCS is used for PSIP and inband EAS messages that are targeted to hosts,
such as QAM tuner TVs, the PSIP_INSERT_RATE variable should not be
present in the .profile. If it is present in the .profile file, it should not be set to 0.
such as QAM tuner TVs, the PSIP_INSERT_RATE variable should not be
present in the .profile. If it is present in the .profile file, it should not be set to 0.
SI_REGENERATION_TIME
The SI_REGENERATION_TIME variable in the .profile file needs to be set to 1200
(20 minutes) so that SI updates happen, at most, once every 20 minutes.
(20 minutes) so that SI updates happen, at most, once every 20 minutes.
Complete the following steps to check the PSIP_INSERT_RATE and
SI_REGENERATION_TIME variables in the .profile file.
1 If necessary, open an xterm window on the DNCS.
2 Type the following command and press Enter:
SI_REGENERATION_TIME variables in the .profile file.
1 If necessary, open an xterm window on the DNCS.
2 Type the following command and press Enter:
grep PSIP_INSERT_RATE /export/home/dncs/.profile
3 Do the results from step 2 reveal that the PSIP variable already exists in the
.profile file?
If yes, and if the DNCS is NOT used for PSIP and inband EAS targeted to
hosts, continue with step 4.
hosts, continue with step 4.
If no, and if the DNCS is NOT used for PSIP and inband EAS targeted to
hosts, skip to step 5.
hosts, skip to step 5.
If no, and if the DNCS is used for PSIP and inband EAS targeted to hosts, go
to step 8; no .profile changes for the PSIP_INSERT_RATE are required.
to step 8; no .profile changes for the PSIP_INSERT_RATE are required.