Cisco Headend System Release 2.5 Installation Guide
Configure Apache to Allow the Client Connection
4038415 Rev A
109
Configure Apache to Allow the Client Connection
Create the Directive for the loadPIMS Service
1 Use a text editor to create the /etc/apache2/conf/loadPIMS.https file with the
following directives.
Note: If this file already exists, see Configure Client IP Addresses for the
loadPIMS Service (on page 111) to allow a connection to the loadPIMS web
service.
Example: The file should look similar to the following example:
Note: If this file already exists, see Configure Client IP Addresses for the
loadPIMS Service (on page 111) to allow a connection to the loadPIMS web
service.
Example: The file should look similar to the following example:
<Location /dncs/soap/loadPIMS>
# SSLVerifyClient none
# SSLCipherSuite +ADH-RC4-MD5
ProxyPass
http://localhost:18284/dncs/soap/loadPIMS
ProxyPassReverse
http://localhost:18284/dncs/soap/loadPIMS
Order Deny,Allow
Allow from localhost
Allow from dncs
Allow from appservatm
#Allow from client_ip
Deny from all
</Location>
Note: Port number 18284, used in the example, should match with the value of
the SERVER_PORT variable in the
/dvs/dncs/etc/LoadDhctServerSOAPCfg.cfg file.
the SERVER_PORT variable in the
/dvs/dncs/etc/LoadDhctServerSOAPCfg.cfg file.
2 Comment out, if applicable, the following lines in rpcserver.conf file:
#ProxyPass /dncs/soap/loadPIMS
http://localhost:18284/dncs/soap/loadPIMS
http://localhost:18284/dncs/soap/loadPIMS
#ProxyPassReverse /dncs/soap/loadPIMS
http://localhost:18284/dncs/soap/loadPIMS
http://localhost:18284/dncs/soap/loadPIMS