Cisco Model D-PCG1000 PowerKEY CAS Gateway Release Notes
Install MQAM Software onto the DNCS
402057 Rev C
17
9 Complete one of the following options:
If the File Manager is present: From the File Manager window, click File
and select Eject. The CD is ejected from the CD drive and the File Manager
window closes.
and select Eject. The CD is ejected from the CD drive and the File Manager
window closes.
If the File Manager is not present: From an xterm window, type the
following command: cd /.; eject; exit. The CD is ejected from the CD drive.
following command: cd /.; eject; exit. The CD is ejected from the CD drive.
10 Type exit and press Enter to close the xterm window.
11 Go to Establish a Download Sequence (on page 19).
11 Go to Establish a Download Sequence (on page 19).
Installing the MQAM Software from Our FTP Server
Creating the Directory
1 From the xterm window where you are logged in as root, type
1 From the xterm window where you are logged in as root, type
cd /export/home/dncs/download and press Enter. The
/export/home/dncs/download directory becomes the working directory.
Important: If this directory does not exist, use the mkdir command to create it.
Then, repeat step 1.
/export/home/dncs/download directory becomes the working directory.
Important: If this directory does not exist, use the mkdir command to create it.
Then, repeat step 1.
2 Type mkdir MQAM320 and press Enter. The system creates a subdirectory
called MQAM320 in the /export/home/dncs/download directory.
3 Type cd MQAM320 and press Enter to access the MQAM320 directory.
4 Go to Obtaining the MQAM Software File (on page 8).
4 Go to Obtaining the MQAM Software File (on page 8).
Decompressing and Extracting the File
1 From the xterm window, type gzip -d MQAM_3.2.0.tar.gz and press Enter. The
1 From the xterm window, type gzip -d MQAM_3.2.0.tar.gz and press Enter. The
system decompresses the MQAM software file.
2 Type tar xvf MQAM_3.2.0.tar and press Enter. The system extracts the
individual files.
3 Go to Installing MQAM Software (on page 17).
Installing MQAM Software
1 From the xterm window where you are logged in as root, type
1 From the xterm window where you are logged in as root, type
/usr/sbin/install_pkg and press Enter.
Results:
Results:
The system lists the packages that will be installed.
A confirmation message appears asking you to confirm that you want to
proceed with the installation.
proceed with the installation.
2 Type y and press Enter to start the installation.
Note: The installation should take less than 30 seconds.