Cisco Headend System Release 2.5 Release Notes
DNCS and Application Server Hardware Platforms
4035750 Rev A
17
DNCS and Application Server Hardware Platforms
Introduction
This section describes the hardware configurations that are supported by SR 5.0.
Running the Doctor Report
1 If necessary, open an xterm window on the DNCS.
2 Type cd /dvs/dncs/Utilities/doctor and then press Enter. The
2 Type cd /dvs/dncs/Utilities/doctor and then press Enter. The
/dvs/dncs/Utilities/doctor directory becomes the working directory.
3 Type doctor and then press Enter. The system generates a list of parameters that
you can use to run the Doctor Report. Each parameter causes the Doctor Report
to generate output with specific configuration information.
to generate output with specific configuration information.
4 Type doctor -g and press Enter to view the version of DNCS software installed
and the DNCS and Application Server platform, CPU, and disk information.
What to Verify Using the Doctor Report
Using the results of the Doctor Report, verify that your system meets the following
requirements. For detailed information on reading the data in the Doctor Report, see
the DBDS Utilities Version 6.4 Installation Instructions and User Guide (part number
4040232).
requirements. For detailed information on reading the data in the Doctor Report, see
the DBDS Utilities Version 6.4 Installation Instructions and User Guide (part number
4040232).