Cisco Model D-PCG1000 PowerKEY CAS Gateway Release Notes
Chapter 2 Upgrading the Software
18
4009746 Rev B
Download Software to the Netcrypt Bulk
Encryptors
Encryptors
Introduction
To download the new software to Netcrypt Bulk Encryptors, you must first reset
(reboot) the units by using one of the following methods:
(reboot) the units by using one of the following methods:
DNCS Administrative Console
POWER switch on the back panel of the unit
CAUTION:
All active sessions on the Netcrypt Bulk Encryptor will be interrupted when
the bulk encryptor is reset. DHCTs downstream of the bulk encryptor will
lose their ability to display services until sessions are reestablished.
All active sessions on the Netcrypt Bulk Encryptor will be interrupted when
the bulk encryptor is reset. DHCTs downstream of the bulk encryptor will
lose their ability to display services until sessions are reestablished.
Important! Use Preparing to Monitor Remote Netcrypt Bulk Encryptor Resets (on
page 18) when resetting Netcrypt Bulk Encryptors from the DNCS Administrative
console.
page 18) when resetting Netcrypt Bulk Encryptors from the DNCS Administrative
console.
After the bulk encryptors reset, the software is downloaded from the DNCS to the
bulk encryptors and existing sessions are reestablished.
bulk encryptors and existing sessions are reestablished.
Choose a Reset Method
Choose one of the following methods to reset your Netcrypt Bulk Encryptors:
To reset bulk encryptors through the DNCS Administrative Console, go to
Preparing to Monitor Remote Netcrypt Bulk Encryptor Resets (on page 18).
Preparing to Monitor Remote Netcrypt Bulk Encryptor Resets (on page 18).
To reset bulk encryptors through the POWER switch, go to Physically Resetting
the Netcrypt Bulk Encryptor (on page 20).
the Netcrypt Bulk Encryptor (on page 20).
Preparing to Monitor Remote Netcrypt Bulk Encryptor Resets
1 From the xterm window, type cd /dvs/dncs/tmp and press Enter to access the
TMP directory.
2 Type ls -ltr boot* and press Enter. A list of files starting with "boot" appears in
the xterm window.
3 Locate the current bootpd.xxx file name.
Note: This will be the bootpd.xxx file with the highest number and/or the most
recent date.
recent date.
4 Type tail -f bootpd.xxx | grep -i netcrypt to show the last Netcrypt Bulk
Encryptor to reboot.