Cisco Model D-PCG1000 PowerKEY CAS Gateway Technical References
78-4021637-01 Rev B
5
Configure Stat Mux Dejitter Groups
Configure Stat Mux Dejitter Groups
This section describes how to use the Stat Mux Dejitter Groups window to set up
SMDGs on GQAM modulators that receive multiplexed sources. You can set up a
maximum of 16 SMDGs on a GQAM modulator — one SMDG for each RF output
port on the GQAM modulator. Each SMDG can accommodate a maximum of 60
sessions.
Important! Setting up an SMDG enables the GQAM modulator to appropriately
Important! Setting up an SMDG enables the GQAM modulator to appropriately
process multiplexed sources. Failing to set up SMDGs on GQAM modulators that
receive multiplexed sources may result in tiling (macroblocking) of the video on
DHCTs.
Before You Begin
Software Required
Before you begin, make certain that you have the following software installed on
Before you begin, make certain that you have the following software installed on
your system:
GQAM software release 4.0 or later
DNCS SR 2.7/3.7/4.2 SP2 or later
Information Required
You will need your network map and the following information:
You will need your network map and the following information:
The input ports that receive the multiplexed source (ASI inputs, Ethernet inputs,
or both)
If a GbE port is used for multicasting, the destination multicast IP address (IP
multicast address) for the GQAM modulator
If a GbE port is used for unicasting, the destination UDP port number on the
GQAM modulator that receives the source
GQAM output port number that modulates the source onto the network
Note: All of this information should be recorded on your network map. However, if
it is not, contact your system administrator to obtain the information.