Cisco Model 6109 6 MHz Off-Air Reference (NTSC) Installation Guide
Adding and Deleting USRM Service Groups Using Configuration Files
78-4021139-01 Rev D
383
The configuration file QAMs_Stuttgart.txt is shown below.
create gqam GQAM02
adminstate=preprovision
CtrlIpAddress=172.16.6.3
PortTable.ServiceGroupId.1 5
PortTable.ServiceGroupId.2 15
PortTable.ServiceGroupId.3 0
PortTable.ServiceGroupId.4 0
PortTable.AdminState.1 InService
PortTable.AdminState.2 InService
PortTable.AdminState.3 OutOfService
PortTable.AdminState.4 OutOfService
adminstate=inservice
Object ResourceManager
ServiceGroupTable.AdminState.SGID5 InService
ServiceGroupTable.AdminState.SGID15 InService
Object SdvSm
ServiceGroupTable.Zone.SGID5 1
ServiceGroupTable.Zone.SGID15 0
Note: After the configuration file is created and placed in the opt/usrm/ConfigFiles
directory on the USRM, you must enter the configuration file's name on the Platform
- ConfigManager - Configuration Files page as shown, and click Commit Changes.
This loads and processes the file to add the service group.
Deleting Service Groups From a USRM
Note: This procedure requires the modification of the resource configuration file
created in the Adding Service Groups to a USRM procedure, as well as the creation
of two other configuration files as described in this section.
Deleting a service group and other resources from a USRM in release 1.5.0 and later
Deleting a service group and other resources from a USRM in release 1.5.0 and later
requires a process that is a combination of procedures on the USRM as well as on the
DNCS. The basic flow of the process is as follows.
1 From the USRM, release all of the sessions associated with the service group in
1 From the USRM, release all of the sessions associated with the service group in
the Resource Manager.
2 From the DNCS, remove the service group from the USRM.