Cisco DNCS System Release 2.2 3.2 Release Notes
78-4001158-01 Rev C
SR 2.2 and SR 3.2 Service Pack 2 Installation Instructions
2-39
Reset the MQAM Modulator,
Continued
Which Reset Method to Use
You have the following methods available when you reset MQAM modulators:
•
•
You can use the traditional method of resetting modulators through the DNCS
GUI.
•
You can reset the modulators through the back panel of the modulators.
•
You can use auditQAM to reset MQAM modulators.
If your modulators are located at a remote hub or some other distant location, reset
the modulators through the DNCS or by using the auditQAM utility. In this case,
someone will need to be onsite remotely to note and verify the session and program
counts for each MQAM modulator.
If your MQAM modulators are located at the headend, you can reset the modulators
If your MQAM modulators are located at the headend, you can reset the modulators
through the modulator back panel.
Notes:
•
Notes:
•
Instructions for resetting MQAM modulators through the DNCS GUI are found in
Resetting MQAM Modulators Through the DNCS GUI, next in this section.
•
Instructions for resetting MQAM modulators through the back panel of the
modulator are found in Resetting MQAM Modulators From the Back Panel, later
in this section.
•
In addition, the Troubleshooting and Resetting QAMs and MQAMs With auditQAM
Instruction Sheet, part number 4005744, contains instructions for resetting QAM
and MQAM modulators.