Cisco Cisco StadiumVision Mobile Streamer Maintenance Manual

If the DHCP server is limited to a single Option 43 string per DHCP pool (such as

with a Cisco DHCP server), then be sure to configure a separate DHCP scope for

each media player model.

Configure the DHCP Option 60, Vendor Class Identifier string:

DMP-2K string for new, factory-shipped devices: "Cisco DMP-2K"

NOTE: For early device prototypes, the DMP-2K string is
"BrightSign DMP-2K".

SV-4K string for North America: "Cisco SV-4K-NA"

SV-4K string for all other regions: "Cisco SV-4K-ROW"

Configure the converted DHCP Option 43, Vendor Specific Option URL:

http://x.x.x.x:8080/StadiumVision/dmp_v4/scripts/boot.brs

where “x.x.x.x” is the IP address of the Cisco StadiumVision Director server.

IMPORTANT: The option 43 string must be converted to TLV
format for compatibility with the SV-4K and DMP-2K. For more
information, see

"Appendix: SV-4K and DHCP Option 43" on

page 1

Connected Stadium Switch Requirements

This section highlights some of the key requirements to plan your Connected Stadium

switch configuration. However, it does not describe all of the details for you to perform

the configuration. For configuration details, see the

available to qualified Cisco StadiumVision partners.

Switch Configuration Requirements for the SV-4K and DMP-2K Media Player

Be sure that the Connected Stadium switch meets the following configuration

requirements to support the deployment of the SV-4K and DMP-2K media players:

Supports PoE+ (IEEE 802.3at) with 30W of port power.

Configures Internet Group Management Protocol (IGMP).

IGMPv1, IGMPv2, and IGMPv3 are supported.

Configures Link Layer Discovery Protocol (LLDP), which is required to determine

available power using PoE+ and also supports the IOS Civic Location feature.

31 of 80