Cisco Cisco StadiumVision Mobile Streamer Maintenance Manual
© 2011 Cisco Systems, Inc. All rights reserved. This document is Cisco Internal Information. Page 10 of 23
5. Enter the URL for the multicast group (address + port) of the video stream you
want to use for the default channel. This URL is typically provided by the
StadiumVision headend engineer.
StadiumVision headend engineer.
6. Click Apply.
Figure 6.
Defining the Default Channel
Defining a Default Channel for a DMP
You can also define the default channel on a per DMP basis as follows. If this value
is not defined, the DMP will use the default channel defined in the Registry.
is not defined, the DMP will use the default channel defined in the Registry.
1. Open the Management Dashboard.
2. Select the Configuration tab.
3. Select the DMP.
4. Select the TV Commands > Set Video Channel command.
5. Select the DMP type: 4305 or 4310.
6. In the parameters settings, enter the URL for the multicast group (address +
port) of the video channel you want to play on the TV controlled by the selected
DMP. This URL is typically provided by the StadiumVision headend engineer.
DMP. This URL is typically provided by the StadiumVision headend engineer.
7. Click the Play button to send the command to the selected DMP.
8. Refer to Figure 7.