Cisco Cisco ACNS Software Version 5.5 Quick Setup Guide
16
Figure 16
Wiring the DC Connector
Note
Use only two strands of wire for the DC connector. Do not wire the DC connector ground terminal
shown in Figure 15. To ground the chassis, follow the grounding instructions in the “Ground the
Chassis” section on page 12.
shown in Figure 15. To ground the chassis, follow the grounding instructions in the “Ground the
Chassis” section on page 12.
Step 9
Tighten the cable clamp screws.
Step 10
Slide the shell over the DC terminal block and tighten the shell screw.
Step 11
Tighten the strain-relief compression nut.
Step 12
Plug the DC power cord into the DC power supply receptacle.
Step 13
Connect the other end of the DC power cord to your site DC power source.
Step 14
Repeat Step 1 through Step 11 for all power supplies in your system.
Step 15
Power up the device.
The system should begin booting. Once the operating system boots, you are ready to perform an initial software
configuration.
configuration.
6
Perform an Initial Startup Configuration
After you physically install the hardware and power up your Content Engine, Content Router, or Content Distribution Manager,
you must access the ACNS software and perform an initial startup configuration.
you must access the ACNS software and perform an initial startup configuration.
Initial Startup Overview
The initial configuration defines the network settings of your Content Engine, Content Router, or Content Distribution Manager
so that your devices become active on your network.
so that your devices become active on your network.
Note
If you have upgraded your software from a previous software release to ACNS software, your network
configuration is preserved. You do not need to reconfigure your network settings.
configuration is preserved. You do not need to reconfigure your network settings.
52867
–48 volt wire
0 volt wire
3
2
1