Cisco Cisco 1 GHz GainStar Amplifier Installation Guide
Installation and Configuration
19
Installing the Accessories
To Install the Attenuator Pads
Complete the following steps to install the attenuator pads in the GainStar Line
Extender.
Note: For the best results, follow this installation procedure exactly.
1 Start this procedure with the housing open. Refer to Opening the Line Extender
Extender.
Note: For the best results, follow this installation procedure exactly.
1 Start this procedure with the housing open. Refer to Opening the Line Extender
Housing.
Note: These accessories can be installed without removing the cover.
Note: These accessories can be installed without removing the cover.
2 Install the pad(s) specified by the design print in the appropriate pad slot(s).
Note:
Be sure that all the pins on the attenuator pad bottom align with the pin holes
in the attenuator pad slot, allowing the attenuator pad to be installed flat
against the GainStar Line Extender module.
in the attenuator pad slot, allowing the attenuator pad to be installed flat
against the GainStar Line Extender module.
The forward output pad and forward interstage pad (1 GHz: 1 dB) are
installed at the factory to set the operational gain of the station. Do not
change these pads in the field unless required by system design.
installed at the factory to set the operational gain of the station. Do not
change these pads in the field unless required by system design.
3 Install other options or accessories as desired.