Cisco Model D9479 Gigabit QAM Modulator Installation Guide
Chapter 2 Upgrading the Software
24
78-4024239-01 Rev B
auditQam -reset 123.123.123.123
sleep 1
auditQam -reset 123.123.123.124
sleep 1
auditQam -reset 123.123.123.125
sleep 1
auditQam -reset 123.123.123.126
sleep 300
# end of first set
auditQam -reset 123.123.123.127
sleep 1
auditQam -reset 123.123.123.128
sleep 1
auditQam -reset 123.123.123.129
sleep 1
auditQam -reset 123.123.123.130
sleep 300
# end of second set
After resetting the modulators, select one of the following options:
After resetting the modulators, select one of the following options:
For modulators that carry broadcast sessions, go to Verifying the Functionality
of GoQAM Modulators That Carry Broadcast Sessions (on page 25).
For modulators that carry xOD or VOD sessions, go to Verifying the
Functionality of GoQAM Modulators That Carry xOD or VOD Sessions (on
page 26).
Physically Resetting the GoQAM Modulator
1 Record the Session Count and the Program Count for your modulators by
completing the following steps:
Note: Skip this step for any modulator that is used for VOD.
a Press the Options button on the front panel until the Session Count total
Note: Skip this step for any modulator that is used for VOD.
a Press the Options button on the front panel until the Session Count total
appears.
b Record the Session Count on a piece of paper.
Note: Press the RF Select button to access each component of the modulator.
c Press the Options button on the front panel until the Program Count total
appears.
d Record the Program Count on a piece of paper.
Note: Press the RF Select button to access each component of the modulator.
e Repeat steps a) through d) for each modulator in your system.
2 Reset the modulator by turning off, and then back on, the power switch located
on the rear panel.
Note: If it is difficult to reach the power switch, you can reset the modulators by
Note: If it is difficult to reach the power switch, you can reset the modulators by
pressing the Options button on the front panel until the Reset option appears.