Cisco Cisco Prisma II EDR Receiver Installation Guide
Chapter 4 Operation Using ICIM
98
78-4025693-01 Rev D
Boot Dialog for ICIM/SNMP Configuration
The boot dialog is presented whenever the ICIM is powered up (a cold boot). It is
accessible via the LCI communications port on the front of the chassis.
Important: A null modem is required along with a terminal emulator program, such
Important: A null modem is required along with a terminal emulator program, such
as HyperTerminal on a Windows PC.
The serial port on the PC used by the terminal emulator program should be set up
The serial port on the PC used by the terminal emulator program should be set up
with these parameters:
9600 baud
8 data bit
No parity bit
1 stop bit
This parameter is often displayed as: 9600 8-N-1.
The primary use of the boot dialog is to flash a new version of the ICIM application
via a TFTP server.
Important: Do this only under the direction of Cisco Services.
Important: Do this only under the direction of Cisco Services.