Cisco Cisco Prisma II EDR Receiver Installation Guide

 

78-4025693-01 Rev D 

99 

 

During a flash operation, the low-level parameters can be changed, including 

community strings, port number for traps, IP address, etc. 
The procedures below initially tell the ICIM that it is to be updated (flashed), 

whereupon it presents a configuration dialog. After new values are entered and 

saved, the ICIM is told to not update the program and proceed to normal ICIM 

operations. 

 

1  When the ICIM is powered up, it presents a summary screen along with a 

prompt to “…press any key within 5 seconds.” The following information 

appears: 

  Start-Up Configuration Dialog

 

  ------------------------------------------------------------

 

  START-UP MODE:

 

    Run ICIM Application

 

  NETWORK INTERFACE PARAMETERS:

 

    IP address on LAN is 192.133.194.219

 

    LAN interface's subnet mask is 0xffffff00

 

  SNMPv1 COMMUNITY:

 

    Read Community: public        Write Community: private

 

    Trap Community: SNMP_trap     Trap Port: 162

 

  HARDWARE PARAMETERS:

 

    Serial channels will use a baud rate of 9600

 

    Board's Serial Number is ^AAIIJHC

 

  HARDWARE PARAMETERS:

 

    ICIM BSP Revision: ICIM Boot Rom, Rev: BT 0204 (02-23-2004)

 

    MPC860 (Rev 0.2) CPU running at 49 Mhz with 5 Mhz input clock

 

    ICIM Board with 16 Mbytes DRAM and 4 Mbytes App FLASH and 2 Mbytes Boot

 

    FLASH

 

    This board's Ethernet hardware address is 0:2:DE:1:2:3

 

  BOOT ROM PARAMETERS:

 

    IP address of the TFTP host is 192.133.194.4

 

    The file to download and start is ram.crc

 

    After board is reset, start-up code will wait 5 seconds

 

  ------------------------------------------------------------

 

  To change any of this, press any key within 5 seconds.

 

Note: During the first couple of seconds, the ICIM does not respond to a key 

press. 

2  Press any key repeatedly until the following prompt appears. 

  

(M)odify any of this or (C)continue? [M]

 

3  Press Enter to get the default value for Modify. 

  For each of the following questions, you can press < Return > to

 

  select the value shown in braces, or you can enter a new value.

 

  How should the board boot?

 

  1. pROBE+ (for debugging)

 

  2. TFTP   (for code download)

 

  3. Run ICIM Application

 

  Which one do you want? [3] 2

 

4  Select 2 for TFTP. 
Note: We will not be doing a code download, but this gets access to the rest of the 

parameters dialog.