Cisco Cisco Prisma II EDR Receiver Installation Guide
Chapter 3 Operation Using CLI
36
78-4025693-01 Rev D
Shortcut
Description
^D
Performs a logout when typed at the beginning of a line
^L
Displays the current input as received by the command interpreter;
used for testing line noise
^P
Moves the text cursor to a previous command line (limited)
^X
Cancels the current input line
Note: While useful for craft operators, avoid using abbreviations and shortcuts in
network management system commands, as they are a potential source of error.
Alarm Information
You can use the alarm command in any command mode to get a list of currently
You can use the alarm command in any command mode to get a list of currently
active alarms in the ICIM domain. You can also change command modes or
additional arguments to narrow the scope of the response, as explained later in this
chapter.
Getting Online Help
Craft operators can type help (or the ? character) and then press Enter to view online
Craft operators can type help (or the ? character) and then press Enter to view online
help screens for each command mode.
The help screens for Module, ICIM, and Terminal modes can be viewed while in CLI
The help screens for Module, ICIM, and Terminal modes can be viewed while in CLI
mode by using the following commands:
help module
help terminal
help icim
Note: A summary of recognized CLI commands by command mode is also provided
in Prisma II Permitted CLI Commands (on page 131).
Login and Logout
To use the CLI, you first establish communication with a chassis using Telnet,
Hyperterminal, or your network management system. Telnet and Hyperterminal
instructions are included in To Enable Optical Output (on page 15).