Cisco Cisco Prisma II EDR Receiver Installation Guide
Using the CLI
78-4025693-01 Rev D
37
Once communication is established, the control console or PC displays the following
message from the ICIM:
---------------------
W A R N I N G
---------------------
Unauthorized or improper use of this system may result in
administrative disciplinary action and civil or criminal penalties.
By continuing to use this system you indicate your awareness of and
consent to these terms and conditions of use. LOG OFF IMMEDIATELY
if you do not agree to the conditions stated in this warning.
login:
Login
Complete the following steps to log into the CLI.
1 At the login prompt, type your assigned user name (or if none is assigned, type
Complete the following steps to log into the CLI.
1 At the login prompt, type your assigned user name (or if none is assigned, type
Administrat0r), and then press Enter. The user name is case-sensitive.
2 At the password prompt, type your assigned password (or if none is assigned,
type AdminPassw0rd), and then press Enter. The password is case-sensitive.
An acknowledgement similar to the following appears:
An acknowledgement similar to the following appears:
Login of user "Administrat0r" successful
Welcome to the ICIM User Interface
Copyright (C) Cisco Systems, Inc., 2005
Proceed to CLI at the shell prompt
shell>
3 To enter the CLI, type cli at the shell prompt, then press Enter. The prompt
changes as shown below.
CLI>
You can now use CLI commands to interact with the ICIM2.
Logout
To log out of the CLI and exit the session, type logout, then press Enter.
Note: CLI always recognizes the logout command, regardless of the current
To log out of the CLI and exit the session, type logout, then press Enter.
Note: CLI always recognizes the logout command, regardless of the current
command mode.