Cisco Cisco Prisma II EDR Receiver Installation Guide
ICIM Commands
78-4025693-01 Rev D
51
Show Provisioning
This command displays a list of the CLI commands needed to restore any
This command displays a list of the CLI commands needed to restore any
replacement modules in the ICIM domain to their current operating states. This list
can serve as a command reference to quickly configure a replacement module so that
it operates identically to the original.
The output is intended primarily for use by a network management system, which
The output is intended primarily for use by a network management system, which
would store the provisioning commands until needed. In the event that a module is
replaced, the system would then send the provisioning commands required to
configure the replacement module to match the operating state of the original.
The following sample dialog shows how a network management system might send
The following sample dialog shows how a network management system might send
the command, and includes a portion of a typical response.
CLI> icim show provisioning exit
. . . .
Module Chassis 20 Slot 5 Set Control Enable On EXIT
Module Chassis 20 Slot 5 Set Control AGC On EXIT
Module Chassis 20 Slot 5 Set Control RFDrive 0 EXIT
Module Chassis 20 Slot 5 Set Control OMISet 0 EXIT
Module Chassis 20 Slot 5 Set Control Master Master EXIT
Module Chassis 20 Slot 5 Set Control CWMode Off EXIT
Module Chassis 20 Slot 5 Set Control LenMode Off EXIT
. . . .
Using the list requires first locating all command lines that target the chassis and slot
location of the replacement module. The commands are then sent to the replacement
module one at a time in the order listed. For example, after replacing the module in
chassis 20 slot 6 in the above example, the commands on lines 6-9 of the response
would be sent to configure the replacement module.
Note: The CLI has no mechanism for accepting multiple commands at a single
Note: The CLI has no mechanism for accepting multiple commands at a single
prompt from either a craft operator or a network management system. It is necessary
to send the first command, wait for a new prompt, send the next command, and so
on until all commands are sent.
Show Traps
This command is used to display the current status of the Trap table. The basic
This command is used to display the current status of the Trap table. The basic
syntax is as follows:
show traps