Cisco Cisco Prisma II EDR Receiver Installation Guide
78-748705-01 Rev C
Operation Using LCI
4-17
Configure the Processor
Introduction
Using LCI, you can configure several parameters.
Configurable Parameters
The table below lists the configurable parameters of the processor.
Parameter
Function
Values
Default
Transmitter 1 Enable
Controls whether
transmitter 1 is enabled or
disabled.
Enable or
Disable
Enable
Transmitter 2 Enable
Controls whether
transmitter 2 is enabled or
disabled.
Enable or
Disable
Enable
Transmitter 1 Service
Controls whether
transmitter 1 is active or
idle.
Active or
Idle
Active
Transmitter 2 Service
Controls whether
transmitter 2 is active or
idle.
Active or
Idle
Active
RF Drive Stream 1A
RF Drive Stream 1B
RF Drive Stream 2A
RF Drive Stream 2A
RF Drive Stream 2B
Attenuates the RF input
channels.
0 dB to
10 dB in
0.1 dB steps
0 dB
Clock Source
Selects the 1 MHz
reference clock source.
Independent
Master
Slave
Independent
Transmitter 1 Noise
Suppression
When set to On, a small
amount of dithering is
added, which suppresses
spurious signals.
On or Off
On
Transmitter 2 Noise
Suppression
When set to On, a small
amount of dithering is
added, which suppresses
spurious signals.
On or Off
On