Cisco Prisma DS3 E3 STS-1 Converter with Remote Management Installation Guide
4008630 Rev B
Prisma FiberLinX Gigabit Module Installation Instructions
19
Software Configuration
Introduction
The following Prisma FiberLinX Gigabit module features are software configurable
via PrismaView software only:
• FX LinkLoss
• FiberAlert
• Bandwidth Control
• Loopback testing functionality
via PrismaView software only:
• FX LinkLoss
• FiberAlert
• Bandwidth Control
• Loopback testing functionality
The following Prisma FiberLinX Gigabit module features are configurable via
PrismaView software or serial/Telnet session:
• Auto-Negotiation
• Selective Advertising
• Force Mode
• Flow Control
PrismaView software or serial/Telnet session:
• Auto-Negotiation
• Selective Advertising
• Force Mode
• Flow Control
Refer to the Help file for configuration information. Refer to Serial
Configuration/Telnet Session later in this document.
Configuration/Telnet Session later in this document.
Auto-Negotiation
The Prisma FiberLinX Gigabit module ships from the factory with Auto-Negotiation
enabled on the twisted-pair ports. In this mode, the ports negotiate for speed and
duplex.
enabled on the twisted-pair ports. In this mode, the ports negotiate for speed and
duplex.
Auto-Negotiation, Duplex Mode and Speed
The twisted-pair ports on the Prisma FiberLinX Gigabit module auto-negotiate for
speed and duplex mode. This device also provides the option of selectively
advertising or forcing the speed and duplex mode. The fiber port operates at 1000
Mbps Full-Duplex. Configure features on twisted-pair ports via the management
software. Refer to the Help file for configuration information.
speed and duplex mode. This device also provides the option of selectively
advertising or forcing the speed and duplex mode. The fiber port operates at 1000
Mbps Full-Duplex. Configure features on twisted-pair ports via the management
software. Refer to the Help file for configuration information.
Forcing the Duplex Mode and Speed
The twisted-pair ports on the Prisma FiberLinX Gigabit module can also be manually
set for 10 Mbps, 100 Mbps or 1000 Mbps operation and for Half- or Full-Duplex (i.e.
10 Mbps Full-Duplex, 10 Mbps Half-Duplex, 100 Mbps Full-Duplex, etc.).
set for 10 Mbps, 100 Mbps or 1000 Mbps operation and for Half- or Full-Duplex (i.e.
10 Mbps Full-Duplex, 10 Mbps Half-Duplex, 100 Mbps Full-Duplex, etc.).
Continued on next page