Cisco Prisma DS3 E3 STS-1 Converter with Remote Management Installation Guide
4008630 Rev B
Prisma FiberLinX Gigabit Module Installation Instructions
5
Laser Safety
Introduction
This equipment contains an infrared laser that transmits intensity-modulated light
and emits invisible radiation.
and emits invisible radiation.
Warning: Radiation
WARNINGS:
• Avoid personal injury! Use of controls, adjustments, or performance of
procedures other than those specified herein may result in hazardous
radiation exposure.
radiation exposure.
• Avoid personal injury! The laser light source on this equipment emits
invisible laser radiation. Avoid direct exposure to the laser light source.
• Do not apply power to this equipment if the fiber is unmated or unterminated.
• Do not stare into an unmated fiber or at any mirror-like surface that could reflect
• Do not stare into an unmated fiber or at any mirror-like surface that could reflect
light that is emitted from an unterminated fiber.
• Do not view an activated fiber with optical instruments (e.g., eye loupes,
magnifiers, microscopes).
• Use safety-approved optical fiber cable to maintain compliance with applicable
laser safety requirements.
Warning: Fiber Optic Cables
WARNING:
Avoid personal injury! Qualified service personnel may only perform the
procedures in this document. Wear safety glasses and use extreme caution when
handling fiber optic cables, particularly during splicing or terminating
operations. The thin glass fiber core at the center of the cable is fragile when
exposed by the removal of cladding and buffer material. It easily fragments into
glass splinters. Using tweezers, place splinters immediately in a sealed waste
container and dispose of them safely in accordance with local regulations.
procedures in this document. Wear safety glasses and use extreme caution when
handling fiber optic cables, particularly during splicing or terminating
operations. The thin glass fiber core at the center of the cable is fragile when
exposed by the removal of cladding and buffer material. It easily fragments into
glass splinters. Using tweezers, place splinters immediately in a sealed waste
container and dispose of them safely in accordance with local regulations.
Continued on next page