Cisco CiscoWorks Network Compliance Manager 1.8 Information Guide

Problem with incorrect switch chassis module memory information with cisco driver is now fixed.

SNMP driver discovery problem with Crossbeam XOS devices is now resolved.

The oOption to disable the creation of child contexts for Cisco FWSM and ACE drivers is available 
now.

Driver discovery problem with Gigamon devices is now resolved.

Cisco ASR driver now uses the old show config command also.

Diagnostic problems with the Huawei driver is now fixed.

Snapshot problem with the Cisco 2800 device has been resolved. 

Snapshot failure problem with Cisco FWSM has been fixed.

Device access problem with CiscoIOSCommon driver has been resolved.

Module information parsing problem with Cisco Catalyst driver is now fixed.

Cisco Nexus driver now uses show inventory command to parse the module information.

Configuration deployment to start-up is not supported by Cisco Nexus devices.

NortelERS driver now supports binary configuration deployment.

Module diagnostics failure with Cisco Nexus driver, when Hardware Revision is longer than 128 
characters is resolved.

Arista Driver now parses for the correct hostname.

Nexus driver problem with extra # characters from copy run start command is now fixed.

Snapshot problem with Radware driver is now resolved.

Alcatel_JS driver now masks out the timestamps.

Snapshot problem with the Fortigate driver is now resolved.

VLAN parser in CiscoIOS_JS now works fine withe 32-bit NCM installations.

 lists the device drivers supported by CiscoWorks NCM 1.5 and later. This table is cumulative 

and will be updated every time new device driver support is available for these releases.

3Com

Router S7910E

5.2

3Com

SuperStack II Switch 3300

2.x

3Com

SuperStack III Switch 4200

3.00c68

3Com

SuperStack III Switch 4400

3.x, 6.13s

3Com

Switch S4210

V3.01.13s56

3Com

Switch S4210 PWR 9-Port

3.01.02s56

3Com

Switch 4500-PWR-26

3.3.2

3Com

Switch 4500G (Comware)

5.02

3Com

Switch S4800G PWR 48-port

5.2