Cisco Cisco Prisma II EDR Receiver Installation Guide
High Density Transmitter Parameters
78-4023013-01 Rev C
91
Configurable Parameters
Parameter
Name (LCI)
ICIM
Abbreviation
Description
Values
Default
Laser Enable
Enable
Enables or disables amplifier
operation, i.e., turns the laser on or
off.
ON (1) = Enabled
OFF (0) =
Disabled
ON (1)
CW Mode
CwMode
Automatically adjusts the
displayed RF input level by
subtracting 3 dB when CW mode
is on.
ON (1) = Enabled
OFF (0) =
Disabled
OFF (0)
Low RF Alarm
Inhibit
LoRFInh
Enables or disables the "RF input
low" alarm.
ON (1) = Alarm
Enabled
OFF (0) = Alarm
OFF (0) = Alarm
Disabled
ON (1)
Master
Master
Configures the module as master
or slave:
If set to Master, the transmitter
is controlled only by the
Enable control above.
If set to Slave, the transmitter
is controlled by a combination
of Enable and the external
input CNT_IN_1.
ON (1) = Master
OFF (0) = Slave
ON (1)
RF Drive Level
RFDrive
Sets the relative RF drive level into
the transmitter.
-5.0 dB to +3.0 dB
in 0.5 dB steps
0.0 dB
Automatic Gain
Control
AGC
Turns automatic gain control on or
off.
ON (1)
OFF (0)
OFF (0)
Length
Length
Sets the fiber length for optimal
performance.
5 to 30 km in 5
km steps
Varies
with
optical
output
power