Cisco Cisco 4G LTE Enhanced High-Speed WAN Interface Cards for Europe

Page of 63
 
 
© 2014 Cisco and/or its affiliates. All rights reserved. This document is Cisco Public Information. 
Page 9 of 63 
4. Cisco 4G LTE Offerings 
 lists the hardware that Cisco introduced to support 4G LTE WWAN. 
Table 3. 
Cisco 4G LTE Product SKUs 
Cisco SKU ID 
Modem 
Speeds 
Cisco IOS 
Software 
Version 
ISP or Region 
Features 
Downlink 
Mbps 
Uplink 
Mbps 
EHWIC-4G LTE-V 
MC7750 
50 
25 
15.3(3)M 
or later 
Verizon 
4G speeds,  
~25-msec latency, 
interface MIBs, data 
callback (voice and 
Short Message Service 
[SMS]), subscriber 
identity module (SIM) 
lock, diagnostics, 
remote firmware 
upgrade,  
4G MIBs, SMS, and 
Global Positioning 
System (GPS) 
C819(H)G-4G-V-K9 
EHWIC-4G LTE-A 
MC7700 
100 
50 
15.3(3)M 
or later 
AT&T 
C819(H)G-4G-A-K9 
EHWIC-4G LTE-G 
MC7710 
100 
50 
15.3(3)M 
or later 
Europe and regions with 
same 3G or 4G bands 
C819(H)G-4G-G-K9 
EHWIC-4G LTE-BE 
MC700 
100 
50 
15.3(3)M1 
or later 
Bell (Canada); 
EHWIC-4G LTE-JP 
MC7700 
100 
50 
15.3(3)M1 
or later 
NTTDocomo (Japan) 
● 
EHWIC-4G-LTE-V: Works on ISR G2 (Cisco 1900, 2900, and 3900) with Verizon 4G LTE network 
● 
C819(H)G-4G-V-K9: Hardened and nonhardened version of Cisco 819 on the Verizon 4G LTE network 
● 
EHWIC-4G-LTE-A: Works on ISR G2 (Cisco 1900, 2900, and 3900) with the AT&T 4G LTE network 
● 
C819(H)G-4G-A-K9: Hardened and nonhardened version 
of Cisco 819 on AT&T’s 4G LTE network 
● 
EHWIC-4G-LTE-G: Works on ISR G2 (Cisco 1900, 2900, and 3900) with global 4G LTE networks 
(FD-LTE only mode) 
● 
C819(H)G-4G-G-K9: Hardened and nonhardened version of Cisco 819 on global 4G LTE networks 
(FD LTE only mode) 
● 
EHWIC-BE: Works on ISR G2 (Cisco 1900, 2900, and 3900) with Bell cellular network in Canada 
● 
EHWIC-JP: Works on ISR G2 (Cisco 1900, 2900, and 3900) with NTTDocomo cellular network in Japan 
The EHWIC-4G-LTE comes with the Sierra Wireless multimode modem. The multimode modems smoothly hand 
off between different modes such as 4G LTE to 3G to 2G as per network availability. You do not need to configure 
it, although you can use the CLI to set a preference for a particular mode. This preference is subject to the ability of 
the network to honor it - and the network can override it. Multimode capability is as per the 3GPP standards. The 
EHWIC can operate in the following modes: 
● 
4G LTE: The 4G LTE mobile specification provides multimegabit bandwidth, a more efficient radio network, 
latency reduction, and improved mobility. LTE solutions target new cellular networks. These networks 
initially support up to 100-Mbps peak rates in the downlink and up to 50-Mbps peak rates in the uplink. 
The throughput of these networks is higher than the existing 3G networks. 
● 
3G Evolution-Data Optimized (EVDO or DOrA) mode: EVDO is a 3G telecommunications standard for the 
wireless transmission of data through radio signals, typically for broadband Internet access. DOrA refers to 
EVDO Rev A. This mode is supported with only the -V version of the LTE products.