Cisco Cisco TelePresence Management Suite (TMS) Version 15 Release Notes
Resolved issues
Cisco TMS Release Notes (14.3.2)
Page 25 of 52
Identifier
Description
CSCui24592
Cisco TMS now checks all NTP server entries for a system. Previously it checked only the first
entry which, if blank, resulted in there being no NTP server setting for the system in Cisco TMS.
entry which, if blank, resulted in there being no NTP server setting for the system in Cisco TMS.
CSCuh57929 Resolved the issue where scheduled software upgrades of systems could occur before the
scheduled day and time.
CSCui16561
Resolved the issue affecting Room type systems where if
Systems > Navigator >
select a system
of type Room
> Settings > Edit Settings >
Allow Incoming SIP URI Dialing was checked, the
same field did not show as enabled in the
View Settings
window.
CSCui85980
Resolved the issue where the Filter Name was not displayed when creating a global ticket filter in
Systems > Navigator >
select a system
> Settings > Ticket Filters
.
CSCud04905 Removed the AllowWebSnapshots setting from
Configuration Templates
. This setting cannot be
applied remotely.
CSCuh53350 Removed the Replace System option for systems registered to a Unified CM, as they do not
support this feature.
CSCue50533 Removed IP dialing for Cisco TelePresence T1 and T3 systems as this feature is not supported.
CSCui07157
Resolved the issue where Cisco TMS identified a Cisco TelePresence TX1310 as a three screen
system, allocating three times as much bandwidth as it should to these systems. This could cause
scheduling of TX1310s in multipoint conferences to fail as Cisco TMS incorrectly believed the
bridge had no more available bandwidth.
system, allocating three times as much bandwidth as it should to these systems. This could cause
scheduling of TX1310s in multipoint conferences to fail as Cisco TMS incorrectly believed the
bridge had no more available bandwidth.
CSCui24613
Resolved the issue where the Service Contract Status for a Cisco TelePresence Recording
Server displayed as -1 instead of Unknown in
Server displayed as -1 instead of Unknown in
Systems > System Overview
.
CSCui85968
Resolved the issue where Cisco TMS incorrectly displayed the SIP domain of an MCU as the
Active SIP Server Address.
Active SIP Server Address.
CSCui24605
Changed the error message 'This system is provisioned. Phonebooks and Enforce Management
Settings from TMS are disabled.' from an error to an information message.
Settings from TMS are disabled.' from an error to an information message.
CSCuh43150 Resolved the issue where the Last Backup timestamp was missing from the
Systems >
Configuration Backup > Perform Backup
page.
Phone Books
Identifier
Description
CSCuh22305 Resolved the issue where setting Phone Book Access Control permissions for Provisioning
Directory groups failed if there were more than 100 folders.
CSCue66084 Resolved the issue where searching for a contact in a phone book source of type Manual List did
not return any matches unless the Number of Contacts specified was large enough to display all
contacts up to and including the one being searched for.
contacts up to and including the one being searched for.
CSCui24661
Resolved the issue where an error generated on a Phone Book Source did not clear when
navigating to another phone book source that did not have a problem.
navigating to another phone book source that did not have a problem.
Reporting
Identifier
Description
CSCug71311 Resolved several issues with charts in the
Reporting
pages.