Cisco Cisco TelePresence MX700 Maintenance Manual
Cisco TelePresence Endpoints running TC5 and Cisco Unified Communications Manager 8.6
Quick Reference Guide
D14878.06 Administering TC5 Endpoints on CUCM 8.6, January 2013.
www.cisco.com — Copyright © 2013 Cisco Systems, Inc. All rights reserved.
9
Touch
Setting up provisioning
Provisioning allows the video conferencing network
administrators to manage many video systems
simultaneously. In general, you only have to input the
credentials of the provisioning server to each video system;
the rest of the configuration is done automatically.
Contact your Cisco Unified CM (CUCM) provider if in doubt
for any of the provisioning parameters.
About the External Manager address
If the network does not offer DHCP Option 150, the External
If the network does not offer DHCP Option 150, the External
Manager Address must be added manually. Note that any
input in the field will override the setting provided by DHCP.
When the infrastructure is set to Cisco UCM; then CDP (Cisco
Discovery Protocol) will be enabled and if CDP is successful,
the endpoint will discover DHCP Option 150. In this case you
can leave the External Manager Address field blank, as the
DHCP server will provide the address automatically.
About the CTL file
Normally, you will not delete the old Certificate Trust List
Normally, you will not delete the old Certificate Trust List
(CTL), but there are few cases were you will need to delete
the file from the endpoint such as:
• When changing the CUCM IP address.
• When moving the endpoint between CUCM clusters.
• When you need to re-generate or change the CUCM
• When moving the endpoint between CUCM clusters.
• When you need to re-generate or change the CUCM
certificate.
Running the Provisioning Wizard
If you are connecting the system for the first time, the
If you are connecting the system for the first time, the
Provisioning Wizard will start automatically. Otherwise, tap
More > Settings ( ) > Network Settings > Provisioning
.
1. Run the provisioning wizard
a. Click the
Start
button.
b. Choose
Cisco UCM
infrastructure and click
Next
.
c. If required: Enter the IP address or DNS name of the
External Manager of the Cisco UCM cluster TFTP
server in the
Extermal Manager
input field. A soft
keyboard appears when you tap the field.
d. If required: Check the
Delete old Certificate Trust
List (CTL) file
check box. If no CTL file exist on the
endpoint, this option will not be available.
e. Tap
Register
to complete the registration, or
Cancel
to
abort the procedure.
f. When successfully registered a message will appear
and display the URI for the endpoint.
Setting up provisioning
If the system is in sleep mode, press any key on the remote
If the system is in sleep mode, press any key on the remote
control to wake up the system.
1. Configure the provisioning
a. Use the remote control and select
Home > Settings
> Administrator Settings > Advanced Configuration >
Provisioning
.
b. From the drop down list, set the
Provisioning Mode
to
CUCM. The change will take effect immediately.
c. Go to the
ExternalManager
section and the IP address
or DNS name of the External Manager of the Cisco
UCM cluster TFTP server in the
Extermal Manager
input field. Click
Save
to save the changes.
OSD
Contents
Introduction
Endpoint configuration
CUCM configuration
Setting passwords
Appendices
Endpoint configuration