Cisco Prisma II 1310 nm HDTx Transmitters Installation Guide
2-10
Installation
78-748704-01 Rev C
Connect Optical Cables
Introduction
The following instructions explain how to connect optical cables to a processor and
optical receivers.
Fiber Fish Tool Overview
The fiber fish tool that was shipped with the chassis is used to pull (“fish”) an optical
cable from the rear of the chassis to the front of the chassis so the cable can be
connected to an optical connector on the front panel of a module.
At the end of the fiber fish tool is a small hook that allows you to hold an optical
cable so that you can pull it through to the front of the chassis.