Cisco Prisma II 1310 nm HDTx Transmitters Installation Guide
2-12
Installation
78-748704-01 Rev C
Connect Optical Cables,
Continued
Connecting an Optical Cable to an Optical Receiver
This procedure assumes that the optical receiver has not been installed in the
processor.
WARNING:
Avoid damage to your eyes! Do not look into any optical connector while the
system is active. Even if the unit is off, there may still be hazardous optical
levels present.
Follow these steps to connect an optical cable to each optical receiver to be installed.
1.
Attach one end of the optical cable to the optical input connector located on
the front of the optical receiver.
2.
Route the other end of the optical cable to the appropriate optical source.
3.
Repeat steps 1–2 for the second optical receiver.