Cisco DNCS System Release 2.7 3.7 4.2 Technical References
2
749637 Rev C
Change the Time Delay Parameter
Introduction
This section provides instructions for changing the Level 2 application time delay
parameter. The time delay parameter, which is set to zero as the default, resides in the
Service Application Manager (SAM) Service.
Changing the Level 2 Application Time Delay
Complete the following steps to change the time delay parameter for suspending
Level 2 applications.
1. From the DNCS Administrative Console window, select the Application
Interface Modules tab, and click SAM Service.
Result: The SAM Service List window opens.
2. Double-click on the SAM service you want to modify.
Result: The SAM Service window opens.
3. In the Application URL field, after the LEVEL2=true statement, type ;d=<x>.
Note: Replace <x> with the number of seconds of the time delay for the
application. Cisco recommends that you test the application to determine
the optimum time delay.
Example: …LEVEL2=true;d=2
Example: …LEVEL2=true;d=2
4. Click Save.
5. Select File and chose Close.
5. Select File and chose Close.
Result: The SAM Service List window closes.
Important: The time delay parameter that is defined for the Level 2 application is
stored in cache memory. The parameter changes you make are not activated until the
DHCT is rebooted.