Cisco Cisco Network Assistant Version 1.0 White Paper
7
Secure Network Foundation Implementation Guide for Single Site Deployments
Secure Network Foundation
Step 4
After the configuration is delivered to the router, click OK.
Configuring Wide Area Networking
Perform the following steps to configure Wide Area Networking.
Step 1
From the Main menu, click Configure and choose Interfaces & Connections from the Task pane.
Step 2
Choose Ethernet (PPoE or unencapsulated routing) and click Create New Connection.
The Ethernet WAN Configuration Wizard opens. Click Next.
Step 3
For Encapsulation, click Next (if the connection was DSL instead of cable, choose to enable PPoE).
Step 4
For the IP Address, choose the Dynamic option (choose Static if service provide assigns a specific IP
address). Click Next.
address). Click Next.
Step 5
For Advanced Options, do not place a check mark in the PAT check box at this time; this will be done
later. Click Next.
later. Click Next.
Step 6
In the summary window, review the options and click Finish.
Step 7
After the configuration is delivered to the router, click OK.
shows the Interfaces and Connections configuration after you have configured the LAN and
WAN interfaces.
Figure 3
Interfaces and Connections Configuration Window