Cisco Cisco Packet Data Gateway (PDG) Troubleshooting Guide
System Element Configuration Procedures
▀ Creating and Configuring Frame Relay Interfaces and Ports
▄ Cisco ASR 5000 Series System Administration Guide
OL-22970-01
Creating and Configuring Frame Relay Interfaces and Ports
This section shows the minimum configuration required to configure a frame relay interface on a channelized line card.
To create and configure the frame relay interfaces and ports:
To create and configure the frame relay interfaces and ports:
Step 1
Select a channelized line card (CLC) and set the framing method by applying the example configuration in the
Step 2
Configure the path, framing and mapping, and frame relay characteristics for a port by applying the example
configuration in the
configuration in the
I
MPORTANT
:
Before you can move to Step 3, you must configure Peer-NSEI and/or SS7 routing domains as
described in the 3G SGSN Configuration section of the SGSN Administration Guide. Complete Steps 4 and 5 and return
to the procedure when your configuration is complete.
to the procedure when your configuration is complete.
Step 3
Configure the port and data link connection identifier (DLCI) and bind the link to the port by applying the example
configuration in the
configuration in the
Step 4
Configure the appropriate timing source (BITS from the SPIO or line-timing from attached remote) to ensure transmit
synchronization by applying the example configuration in the Configuring Transmit Timing Source section in the
Configuring System Settings chapter.
synchronization by applying the example configuration in the Configuring Transmit Timing Source section in the
Configuring System Settings chapter.
Step 5
Save the configuration as described in the Verifying and Saving Your Configuration chapter.
Setting the Characteristics of the Channelized Line Card
Use the following example to set the operational characteristics, the framing type, the header type, the service type, and
the boot time E1 framing type, for the Frame Relay Channelized Line Card (CLC):
the boot time E1 framing type, for the Frame Relay Channelized Line Card (CLC):
Notes:
Make a note of the information you configure - you will need it again later for the
command used to
configure channel characteristics.
The default
is SONET for the channelized line card.