Cisco Cisco UCS B250 M2 Extended Memory Blade Server Data Sheet

This section lists the upgrade and servicing-related parts you may need during the life of your server. Some 
of these parts are configured with every server or with every UCS 5108 blade server chassis, and some may 
be ordered when needed or may be ordered and kept on hand as spares for future use. See 

An SSD blanking panel (N20-BBLKD-7MM=) must be installed if you remove an SSD from the UCS server. These 
panels are required to maintain system temperatures at safe operating levels, and to keep dust away from 
system components.

Instructions for replacing a CPU and heat sink can be found at the following link:

http://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/hw/blade-servers/B260M4.html

The Pick n Place tool set is used to install a CPU in its socket without damage. It must be used each time a 
CPU is installed in the server.

Instructions for using this tool set are found at the following link:

N20-BBLKD-7MM=

UCS 7 mm SSD Blanking Panel

1

1. This part is included/configured with your UCS server (in some cases, as determined by the configuration of 

your server).

UCSB-HS-01-EX=

CPU Heat Sink for UCS B260 M4 and B460 M4

1

N20-BKVM=

KVM local IO cable for UCS servers console port

2

2. This part is included/configured with the UCS 5108 blade server chassis.

UCS-CPU-EP-PNP=

Pick n place CPU tools for M4CPUs

3

3. This part is included with the purchase of each optional or spare CPU processor kit.

UCS-CPU-GREASE3=

Thermal grease for M4 heat sink seal

3

UCSX-HSCK=

UCS Processor Heat Sink Cleaning Kit (when replacing a CPU)

3

UCS-SD-32G-S=

32 GB SD card module for UCS servers

4

4. Only half the capacity of the 32 GB SD card is available with this server

UCS-SD-64G-S=

64 GB SD Card for UCS Servers

UCS-USBFLSHB-16GB=

16 GB Flash USB drive